INSTALLATION: The carton should contain a removable fabric liner, two adjustable 1-inch wide straps (one short, one long), one adjustable ½-inch wide strap, and a “basket” assembly which consists of a rigid backboard with a square “basket” and two support rods attached to it. Set the fabric liner and adjustable straps aside for now, and remove any packing material from the two support rods. Working one at a time, swivel the rods into a vertical orientation and slip them into the slots at the bottom edge of each side of the basket. The rods should be visible as they pass through to the inside of the basket. Carefully slide each rod into the plastic tube located on the inside wall of the basket. After both rods are fully inserted, push down on the basket floor to make sure the seat is fully assembled and feels stable. The removable fabric liner can now be installed. Find the three slits located about two inches in from one of the edges. This is the back edge, and the three slits should align with the three D- rings along the back edge of the basket. Slip the liner over the D-rings and wrap the other edges over the other three sides of the basket, taking care to line up the various hook-and-loop fasteners along each edge. Adjust the liner inside the basket for the best fit. To remove the liner for washing, follow the above steps in reverse.